Paper Rose banners a different way

Hi again.

I'm back today with cards for Paper Rose Studio.

The cards today that I am sharing use a technique of cutting out a frame by using a stacking die set.
I wanted to create some card using a few bits and pieces that I had previously coloured in but were left over from other projects.

The three cards all use the Banner 2 Large metal stacking set.

To create the frames I have taped two dies together spacing them evenly apart so that the cut out creates a border or frame.

For this card the banner frame is layered up. I have cut out and glued together five layers of the banner frame. I have foiled the leaves and 'trapped" them inside the frame stack to suspend them off the background.

The background has been embossed and then hot foiled using the same embossing folder to add extra texture.

The bird from the Bird Day stamp set has been coloured with Copic markers.

This card has an embossed using a 3D floral embossing folder and Distress oxides. The panel has then been glued into the frame stack of die cuts to create a background.

 Only 4 frames glued together here.

The Peonies stamped flower is coloured with Copic markers.

This card has a heat embossed and inked panel set inside the frame stack, when moved around there is a lovely shine to the flowers. The background has been run through an embossing folder.

Supplies Used:

17802 4 x6 Bird Day stamp set

17304 Hello 4 x 6 Stamp set

16951 Layered Hello Die set

17583 Banner 2 Die set

17502 Gum leaves 1 Die

17148 Peonies clear stamp set

17613 More Flowers 4 x 4 stamp set 

Thank you for stopping by to have a look!

until next time,

Mandy x